Nov 1995 EZ-2000+ Series Ethernet Card Netware Server 4.x Driver Installation ======================================= ****************** * SERVER SETUP * ****************** Method 1 using install menu (for NetWare 4.1 only) ================================================== 1) Copy the appropriate NetWare driver files (from this diskette) to the DOS partition of your hard disk. >md EZ2000 >copy A:\NETWARE\SERVER\*.* C:\EZ2000 --Insert EZ-2000+ Driver disk in 'A' >copy A:\NETWARE\SERVER\NW4X\*.* C:\EZ2000 2) Boot the Novell Server, after the server is started execute "LOAD INSTALL" instruction. : load install 3) Select "Driver Option" and press . 4) Select "Configure network drivers" and press . 5) Select "Select a driver" and press . 6) Press the key to install an unlisted driver. 7) Press to specify a different path (C:\EZ2000) and press . 8) Select "EZ2000.LAN" and copy EZ2000.lan. 9) Config adapter parameter, then Select "Save parameters and load driver". 10) Next time you start up your system, only follow steps 2 to 5 to complete the installation. Method 2 modifying an Existing NetWare 4.x Server ================================================= 1) At any workstation, Login to the Novell server as a SUPERVISOR. 2) Copy all supplied NLM and LAN files to your server's SYSTEM directory: >Copy A:\NETWARE\SERVER\NW4X\*.* F:\SYSTEM 3) At the Novell Server side, execute load install :load install Select Select Modify the server's AUTOEXEC.NCF as following. load EZ2000.LAN (msm.nlm and ethertsm.nlm will be automatically loaded while loading EZ2000.lan) bind ipx to EZ2000 NET=xxxx 4) Shutdown the Server and then turn it ON again. This time, the EZ-2000+ Series ethernet card will be installed as your network card.